Teka DHT 120 Manuel D'instructions page 10

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
Dear Customer,
Congratulations on your choice. We are certain that this
modern, functional and practical device made with first
rate quality materials will fully satisfy your requirements.
Please read all the sections in this INSTRUCTION
MANUAL before using the hood for the first time in order
to obtain maximum performance from the device and
avoid faults which may arise from incorrect use as well
as minor problem solving.
For optimal performance, the external duct should not
exceed FOUR METRES, have more than two 90 ° angles
and its diameter should be at least Ø120
Safety Instructions
• Disconnect the device before
performing any work on the
interior, e.g. during cleaning or
maintenance.
• The excessive accumulation of
grease in the hood and metal filters
may cause dripping and fire risks,
therefore it is necessary to wash
the inside of the hood and the
metal filters at least once a month.
• This device can be used by children
aged 8 and over and persons
with reduced physical, sensory
or mental capabilities or lack of
experience and knowledge, if they
have been given supervision or
proper training in the safe use of
the device and if they understand
the dangers involved. Children
should not play with the device.
Cleaning and maintenance should
be performed by the user and not
by unsupervised children.
• Check that the power voltage and
frequency match those indicated
on the label located on the inside
of the hood. A suitable earth must
be connected (except for Class II
devices, marked with
technical data plate).
• For installation, a connection
method isolated from the fixed
installation should be incorporated,
in accordance with installation
regulations (adjusted to the strength
to be endured and with a minimum
opening between the contacts of
3mm) under overvoltage category
III conditions, for the emergency
shutdown,
replacement. In no event should
the earth pass through this switch.
This switch can be replaced with
a plug if it is accessible in normal
use.
• If the power lead is damaged it must
be replaced by the manufacturer,
its after­sales service or by qualified
personnel in order to avoid potential
danger.
• Air should not be extracted by
ducts used to expel fumes from
equipment powered by gas or
other fuels.
• The room must be adequately
ventilated when the hood will
be used simultaneously with
equipment powered by energy
other than electricity e.g. gas
cookers.
• The excessive accumulation of
grease in the hood and metal filters
may cause dripping and fire risks,
therefore it is necessary to wash
the inside of the hood and the
metal filters at least once a month.
• Do not produce flames under the
hood.
• The bottom of the hood must be
fitted at least 65cm above gas
on the
cleaning
or
light

Publicité

Table des Matières
loading

Table des Matières