Publicité
Les langues disponibles
Les langues disponibles
• CLEANING AND STORAGE
TURN OFF AND UNPLUG TOOL! (Unplug extension cord at power source.)
Use only mild soap and a damp cloth to clean the tool. Never let
any liquid get inside the tool; never immerse any part of the tool
into a liquid. Clean out any clippings which may have accumulated
in the Blower/Vac. When used properly with dry leaves the fan
chamber of your Blower/Vac should remain clean. If damp earth
and debris are ingested some of the particles may build up on the
inside of the fan chamber. If this happens the performance of the
unit will decrease. This area can be cleaned out using a wooden
stick as shown in figure 13 after disconnecting from the power
source. Your Blower/Vac should be stored in a dry place.
WARNING: SHOCK HAZARD. DO NOT POUR OR SPRAY
WATER ON THE TOOL IN AN ATTEMPT TO CLEAN.
Do not store the tool on or adjacent to fertilizers or chemicals.
Such storage can cause rapid corrosion of the metal parts.
Problem
• Unit will not start.
• Unit jammed or clogged.
For assistance with your product, visit our website www.blackanddecker.com for the location of the service center
nearest you or call the BLACK & DECKER help line at 1-800-544-6986.
Recommended accessories for use with your tiller are available from your local dealer or authorized service center. If
you need assistance regarding accessories, please call: 1-800-544-6986
WARNING:
The use of any accessory not recommended for use with this tool could be hazardous.
MAINTENANCE
TROUBLESHOOTING
Possible Cause
• Fan cover or vac tube not installed.
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
• Debris blocking inlet/outlet or fan.
ACCESSORIES
8
13
Possible Solution
• Install fan cover for blow
mode or vac tube for vac
mode.
• Plug tool into a working
outlet.
• Replace circuit fuse.
(If the product repeatedly
causes the circuit fuse to
blow, discontinue
use immediately and have it
serviced at a Black &
Decker service center or
authorized servicer.)
• Reset circuit breaker.
(If the product repeatedly
causes the circuit breaker
to trip,discontinue use
immediately and
have it serviced at a Black
& Decker service center or
authorized servicer.)
• Have cord or switch
replaced at Black & Decker
Service Center or
Authorized Servicer.
• Unplug power cord.
Remove vac tube. Refer to
"Cleaning and Storage
Section - Maintenance".
Publicité
