Hardware Installation; Dash-Mounted Installation; Mounting The Unit - Murphy HelmView HV1000 Manuel D'installation

Hardware Installation

The following instructions will guide you through installing the HelmView display.

Dash-Mounted Installation

Tools needed.
• Drill with 9/64" size bit
• Jig Saw
• Wrench or socket for #6 Keps locking nuts (provided) to studs
Preparing the Dash
Determine the location of the HelmView in the dash. Use the Installation Template (included in
the box) as a guideline to cut a hole in the dash to the specified dimensions. Drill holes where
indicated on the template for the mounting screws.
NOTE: Use the plastic template included in the box whenever possible.
If you must use the paper template from the manual and you downloaded this
document from the FW Murphy website, be aware that the pdf file may not
automatically print to scale. When submitting the file for print, you will need to
select "None" for Page Scaling. Check the accuracy of the printed template by
verifying the measurements labeled on the template are correct.
If this manual was supplied with your product, the template will be correct.

Mounting the Unit

1. Attach the eight threaded studs to the back of the HelmView case.
2. Place the back side of the display through the opening in the dash.
3. Use the studs to line up the unit with the drilled holes.
4. Push the unit through the opening and studs through the drilled holes until the back of
the case is flush.
5. Use the #6 Keps locking nuts provided to tighten unit to the dash. Use the appropriate
wrench or socket to tighten. Torque lock nuts to 8-10 inch pounds.
Section 78
05-19-06 - 2 -
00-02-0603