Nmea Wiring - Murphy HelmView HV1000 Manuel D'installation

NMEA Wiring

NOTE: The NMEA wire harness contains blocking pins that only allow the cable
to be connected to Plug D.
Software Configuration for NMEA Setup
If engines are used on NMEA, then when setting the software configuration, on the System
Settings screen, under Wiring Configuration, select NMEA – Plug D – Port, Stbd.
If only NMEA devices such as GPS or tank sensors are connected to Plug D, and engines are
connected to Plug A or B, then use the appropriate single or dual engine configuration settings.
NOTE: NMEA can be used in conjunction with all other engine options listed in
this manual.
Section 78
05-19-06 - 7 -
00-02-0603