AND BA Serie Guide De Démarrage Rapide page 16

Display Code
EC,E00
EC,E01
EC,E02
EC,E03
EC,E04
EC,E06
EC,E07
7.1. Other display
The automatic sensitivity adjustment notice (the
that the automatic sensitivity adjustment will start.
If the balance is not used for a certain period of time with this indicator blinking, the
balance automatically performs sensitivity adjustment using the internal weight. (The
blinking period depends on the operating environment.)
Tips Although it is possible to continue using the balance even while this indicator is
blinking, use after sensitivity adjustment is completed is advisable in order to maintain
the weighing accuracy.
Communications error
A protocol error occurred in communications.
Check the format, baud rate, etc.
Undefined command error
An undefined command was found.
Check the transmitted command.
Not ready
The received command cannot be executed:
(e.g.) Q command was received when not in weighing mode.
(e.g.) Q command was received while re-zeroing.
Adjust the delay time to transmit a command.
Timeout error
With the timeout parameter set to
approximately 1 second or more while receiving command characters.
Check the communication.
Character length error
The number of characters in the received command has exceeded the
limit. Check the command to transmit.
Format error
The description of the received command is incorrect:
(e.g.) The number of digits of numerical values is incorrect.
(e.g.) There are alphabet characters among the numerical values.
Check the transmitted command.
Parameter setting error
The value of the received command has exceeded the allowed value.
Check the setting range of the numerical value of the command.
EN
Description
16
, there was a wait time of
indicator blinking) indicates