Key Operation - AND BA Serie Guide De Démarrage Rapide

Key operation

Key operations affect how the balance functions. Normal
key operation during measurement is "Press and release
the key immediately" or "Press the key". Please do not
"Press and hold the key (for 2 seconds)" unless required.
Key When pressed and released
Turns the display on and off.
When the display is turned off, only the
standby indicator is displayed.
When the display is turned on, weighing is
possible.
If the password function is enabled, you will
be prompted to enter the password when the
display is turned on. For details, refer to the
separate instruction manual listed in "1.1.
Detailed manuals".
The ON:OFF key is active at any time,
and pressing this key during operation
always turns off the display.
In weighing mode, press the key to turn the
digit for readability on and off.
In counting or percent mode, press the key
to enter the sample storing mode.
Switches the weighing units stored in the
function table.
Performs sensitivity adjustment of the
balance using the internal weight.
Stores or outputs the weighing value when
stable according to the function table
settings.
(Data is output at factory setting.)
Performs tare operation.
Sets the displayed value to zero.
IR sensor (touchless sensor).
It reacts when you bring your hand close to
it.
Opening and closing of the breeze break
door are assigned.
For details, refer to "5. IR Sensors and
Auto Doors".
EN
Press the key
(Press and release
the key immediately.)
When pressed and held (for 2 seconds)
Switches the IR sensor on and off.
Enters the function table mode. Please
refer to the separate instruction manual
listed in "1.1. Detailed manuals".
Runs the repeatability check function when
pressed and held for another 2 seconds
after the function table menu is displayed.
For details, refer to the separate instruction
manual listed in "1.1. Detailed manuals".
Enters "Changing Weighing Speed" mode.
Displays the menu related to sensitivity
adjustment.
Enters mode to change the unit weight
registration number in counting mode.
The following settings are possible with the
function table:
Outputs "Title block" and "End block" for
GLP/GMP report.
Displays the data memory menu.
11
Press and hold
the key for 2
seconds.
-
-
-