Before Starting - K&S BASIC KSB 12i S Mode D'emploi

CHECK THE FUEL LEVEL CHECK THE FUEL LEVEL
1. Unscrew the fuel cap and check the fuel level in the tank.
2. Fill the fuel tank to the fuel filter level.
3. Tighten the fuel cap securely.
IMPORTANT!
Recommended fuel: Unleaded gasoline
Fuel tank volume: see specifications table.
CHECK THE OIL LEVEL CHECK THE OIL LEVEL
Generstor is transported without the motor oil. Please don't start the engine
without filling the sufficient amount of motor oil.
1. Unscrew the oil dipstick and wipe it out with a clean cloth.
2. Insert the dipstick without screwing it in.
3. Check the oil level by a mark on the oil dipstick.
4. Add oil if its level is below the mark on the oil dipstick.
5. Screw on the dipstick.
Recommended engine oil: SAE 10W-30, SAE 10W-40.
Recommended engine oil grade: API Service SE type or higher.
Motor oil quantity: see specifications table.
Before starting the engine, make sure that the rated power of power consumers matches with the power of
generator. Do not exceed the nominal power of the generator. Do not connect any devices before you start
the engine!
Do not tilt the generator when adding engine oil. This could result in over filling and damage to the engine. The
generator can be used with the rated output load at standard atmospheric conditions.
IMPORTANT!
ATTENTION - DANGER!
COMMISSIONING COMMISSIONING
1. Fill the crankcase with engine oil. The recommended amount of oil for each model is indicated in the specification
chart.
2. Check oil level with an oil dipstick. It should be between the MIN and MAX marks on the oil dipstick.
3. Check fuel level.
4. Check the air filter for correct installation
Immediately wipe off spilled fuel with a clean, dry, soft cloth,
since fuel may deteriorate painted surfaces or plastic parts. Use
only unleaded gasoline. The use of leaded gasoline will cause
severe damage to internal engine parts.
Do not change the controller settings in terms of the amount of
fuel or speed governor (this adjustment was made at the factory).
Otherwise, this may result in changes in the engine operation or
its failure.
In the power supply mode, the generator should operate no longer
than 1 minute in the range from nominal to maximum power.

BEFORE STARTING

STARTING TO WORK
www.ks-power.de/en
6
fill to here
7
| 19