Operating Elements And Connections; Safety Notes - Monacor NANO-2001 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
All operating elements and connections can be
GB
found on the fold-out page 3.
1 Operating Elements
and Connections
1 Switch X-OVER for selecting the filters:
LP
for bass speakers or a subwoofer,
low pass switched on
FULL for full range speakers,
no filter switched on
HP
for mid-high range speakers,
high pass switched on
2 Trimming control X-OVER to adjust the cross -
over frequency (50 – 500 Hz)
3 Trimming control GAIN for matching the input
level
4 High level inputs HIGH INPUT for connection to
speaker outputs, as an alternative to the RCA
input jacks (6)
5 SPEAKER terminals
6 RCA jacks INPUT for the input signals
(line level)
7 Ground terminal GND
8 Control input REM for switching on the power
amplifier via a 12 V voltage
9 Terminal BATT for the operating voltage +12 V
10 Fuse: 40 A
Only replace a blown fuse by one of the same
type!
11 Power LED
green = correct operation
red =
protective circuit activated
(
switching-on
8
chap ter 8), e. g. shortly during

2 Safety Notes

The power amplifier corresponds to the directive for
automobiles. The test number is indicated on the
unit.
WARNING When connecting the car HiFi power
amplifier to the car battery, be espe-
cially careful. In case of short circuits
there may be dangerously high cur-
rents. Therefore, prior to the connec-
tion, it is indispensable to screw off the
negative terminal of the car battery.
The power amplifier must be mounted to a
mechanically stable place in the car. It must be
skilfully fixed so that it does not get loose and turn
into a dangerous projectile.
During operation the unit may become very hot.
Therefore, do not place any objects sensitive to
heat close to it and do not touch the power ampli-
fier while in operation.
G
For cleaning only use a dry, soft cloth, never use
chemicals or water.
G
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is not
correctly installed or operated, or not repaired in
an expert way.
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment.
3 Caution in Case of High Volumes
CAUTION Never adjust the volume very high.
Extremely high volumes may dam-
age your hearing. The human ear
gets accustomed to high volumes
which do not seem to be so high any
more after some time. Therefore, do not further
increase a high volume which has once been
adjusted after getting used to it.
While driving in the car, signal sounds, e. g. by an
ambulance, must not be drowned by the volume
of the car HiFi system which has been adjusted
too high.
With the motor switched off, the car HiFi system
should not be in operation at high volume for a
longer period of time. The car battery will quickly be
discharged, and then it may not be capable any
more of supplying sufficient energy for starting the
car.

Publicité

Table des Matières
loading

Table des Matières