Safety Instructions; Parts Supplied - Eneo VPT-40 Serie Instructions De Service

Safety instructions

The following instructions are for your own safety and
should be observed without fail.
• Please read these safety and operating instructions
before putting the system into operation.
• Keep the operating instructions in a safe place for
later use.
• Only connect the equipment to a suitable power source.
• Pay attention to safety requirements when laying the
power cable and lay it so that it is not subject to
heavyloads, kinks or damage and no moisture can get in.
• In case of service disconnect the cable from the
control unit.
• 230V control voltage versions must be fitted with a
cable having a minimum core cross-section of
0.75mm . An easily accessible multi-pole disconnec-
2
ting device is to be installed near the pan/tilt head
for isolation of the unit during service work.
Low-resistance protective earthing is required in
accordance with DIN-VDE 0100.
• The warranty becomes void if repairs are undertaken by
unauthorized persons.
• Contact the supplier if any functional problems arise.
II Parts supplied
• Motor/base assembly
• Mounting platform („L"-Bracket)
• 3mm allen wrench
• Mounting screws, washers and nuts
• Cable connector
• Installation manual
III Assembly
At installation the platform and load should be adjusted to
give minimum out of balance of the load (see fig. 1).
Use the supplied screws M4.
Figure 1
Attention!
At no time should this Pan/Tilt be rotated or
positioned by hand. Doing so can permanently
damage the gear drive.
All warranty rights become void under these circum-
stances. The pan/tilt head is supplied ready for connection.
Opening the housing before connection is only necessary
for adjustment of the end switches (see no. VI). If the unit
does not operate, check power supply first (see table no. 1)
and wiring as described under no. V., no. VI and VII should
also be observed.
Operation with 60Hz power supply voltage is also possible
without alteration to the starting capacitor.
IV Mounting
• Mount the pan/tilt in the desired location. There are eight
mounting holes 6.5mm diameter (see fig 2.).
Use the smaller bolt pattern (4" B.C.) or the larger one
(4.75" B.C.) corresponding to the applied mount.
For the fixing use the supplied stainless steel bolts and
nuts. Can be installed standing or suspended (see fig. 3).
M6 hexagonal head screws are used for fastening.
These are pushed into the slot in the base plate from the
outside (use the inner 101.6mm screwhole circle).
The packing contains a prepunched cardboard disc to
assist assembly. This is placed between the housing
and base plate after insertion of the screws and prevents
the screw heads from being pushed out of the hexagonal
recesses (see fig. 2) and turning when the nuts are
tightened.
• Mount the camera housing on the platform in direction
as shown in fig. 4.
• The platform height is adjustable enabling the centre of
gravity of the housing/camera to be closely matched to
the center line of the tilt shaft. Three positions are
possible (see fig. 5).