Closing The Housing; Maintenance Instructions - Eneo VPT-40 Serie Instructions De Service

VIII Closing the housing
Attention must be paid when closing the housing that no
wiring is caught between the housing and cover edges.
Torque per screw 1.5~1.7 Nm.
It is essential to ensure that the seal at the edge of the
aluminium profiles and the plastic covers lies flat.
Too high a torque can destroy the stop at the corner of the
covers. Too low a torque leads to leaks.
Platform:
eneo is a registered trademark of Videor E. Hartig GmbH
®
Exclusive distribution through specialised trade channels only.
Videor E. Hartig GmbH
Carl-Zeiss-Straße 8 · 63322 Rödermark/Germany
Tel. +49 (0) 6074 / 888-0 · Fax +49 (0) 6074 / 888-100
www.videor.com
www.eneo-security.com
IX Maintenance instructions
The main rubber gaskets should be replaced after opening
the housing for maintenance purposes to ensure protection
class IP66 / IP65.
Base:
Dimensions: mm
# 990505
Technical changes reserved.
© Copyright by Videor E. Hartig GmbH 07/2012