Eneo VPT-40 Serie Instructions De Service page 10

Connection for Model: VPT-40/230VPot, Art. No. 73208
a) 7 pin Connector
Pin ID Function
1 Neutral
2 Right
3 Left
4 Up
5 Down
6 Heater (when connected)
7 Case ground
b) 4 pin Connector
1 +
2 -
3 Horizontal
Vertical
4
Figure 6
1 Limit switches (2 off)
2 Setting lever (2 off)
3 Switching lever
4 Potentiometer (when supplied)
5 Central position markings
VI Pan/Tilt limit controls
A) Location
• Access to the limit switches is achieved by releasing the
four bolts (see fig. 1) using the 3mm allen wrench and
removing the cover.
• The limit switches are found on the top gearplate of both
pan and tilt gearboxes and angle adjustment finger
assembly on main shaft end.
B) Limit adjustment (see fig. 6 on the example of the
horizontal one)
• The limit switches can be adjusted with finger pressure.
Push them in the desired angular position for limit
control of the Right/Left, Up/Down direction.
• Refit the cover and tighten the four bolts.
VII Positioning operation
Designs with the „Pot" option (marked accordingly) are to
be chosen for positioning operation. These include a 5kOhm
endlimit free potentiometer on each axle with a utilized
resistance range matching the maximum swivel range of
the individual axles. The pan/tilt head is supplied in centred
position, which is indicated by the markings (see 5 in fig. 6)
being in line. When installing the pan/tilt head, attention
should therefore be paid that the camera's longitudinal axis
is approximately in the middle of the proposed swivel range
so that it can move without problem in a range of ± 180°
horizontally and ± 90° vertically. Using the two markings,
it is always easy to locate the central position again, e.g.
after dismantling.
1
3
4
5
2
5