LaserLiner Duraplane G360 Mode D'emploi page 18

4
Slope mode
Do not release the transport restraint, push the slide switch
(2) to the right and switch on the laser using button 7. Sloping
planes and tilts can now be measured. In this mode, the laser
line no longer aligns automatically. This is indicated by the laser
line flashing.
5
Hand receiver mode
Optional: Working with the laser
receiver GRX
Use a GRX laser receiver (optional) to carry
out levelling at significant distances or when
the laser line is no longer visible.
Manual receiver mode is switched
on automatically.
!
Observe the laser receiver's operating
instructions for line lasers.
Working without laser receivers
To work without laser receivers, switch off the manual receiver mode by pressing
button 7 (hand receiver mode on/off). The laser line will now no longer pulse at
a high frequency and the laser line becomes brighter.
Due to the special optics required to generate a continuous 360° laser
!
line, the underlying technology may cause differences in brightness in
different areas of the line. This may lead to different ranges in hand
receiver mode.
18
EN