max mobility SmartDrive Guide Rapide page 2

3. When the connector is not connected to the SmartDrive, it can be magnetically
connected to the provided metal holder (Fig. C). Position the metal hold between
the front and back parts of the clamp, feeding the top screw through the hole in
the holder. To prevent rattle, tighten the top screw of the clamp completely before
tightening the bottom screw.
4. The position and orientation outlined in the Adaptive Clamp Mounting Instruc-
tions are critical to the proper function of SmartDrive and must be heeded. Refer to
that instruction to make sure the clamp is oriented correctly.
Folding Frame Mount
The two (2) SmartDrive buttons are easily mounted to each side of the
frame of the wheelchair to allow for easy pressing without having to
remove your hands from the handrims.
1. Wrap the velcro loop around the rubber backing of the button then
around the side tubing of the wheelchair; feed the skinny end of the
velcro through the slot in the wider end and pull tightly before laying
down on its mating surface. Be sure the blue LED is pointing up and
the cables that come out of each button run towards the back of the
wheelchair (Fig. D).
Fig. E
2. The cable can be pulled apart to the desired split location (preferably in
the rear of the seat) and any extra cable can be routed at the rear of the
seat. Use the provided tie-straps to route the cables along the frame tubes
and out of the rear of the wheelchair. Be sure the cables do not stick out
and will not get caught in the spokes of the wheelchair (Fig. E).
3. When not in use the cable can be left to dangle out the back. Be sure
to leave enough slack to allow the cables to fold up with the wheelchair
when the chair is collapsed.
Fig. C
Fig. D