Toyotomi Zibro LC-32 Manuel D'utilisation page 20

COPYING THE SETTING FROM ONE DAY TO ANOTHER
Use the copy function if there are multiple days during one week which should
have the same setting times.
Make sure that the heater is not burning. Press the timer key . Use the
adjustment keys N until the day of its source is displayed in the display.
Press extension/day/set  to select.
The display shows:
Use the adjustment keys M or N N to choose copy. Press extension/day/set  to
select the copy function.
Use the adjustment keys M or N N to select the day to which the settings should
be copied. Press extension/day/set  to choose the selected day.
The settings for program for Tuesday are programmed and the display shows
SET for 3 seconds.
After 3 seconds choose another day to copy or end the setting mode by pressing
timer.
OPERATING THE WEEKLY TIMER
Switch on the heater by pressing the POWER button L. And then press the
timer-key  immediately after that. The Timer light will light up and the heater
shuts off. The On / Off indicators on the display shows whether the appliance is
switched on or off.
When the appliance is switched off by the timer, the off indicator is visible. The
display shows the -actual time.
When the appliance is switched on by the timer, the on indicator is visible. The
display shows the desired (set) and actual (room) temperature.
e
iGnitinG tHe HeateR
When used for the first time, a new heater may give out a smell for a short while.
You should therefore provide extra ventilation.
Always ignite the heater with the button L. Never use matches or a
cigarette lighter.
Just press the button L to ignite the heater. The POWER lamp will start blinking,
indicating that the ignition procedure has started. This will take a short while.
Once the heater is burning, the POWER lamp will remain lit (red). The information
display K will show two numbers. The light next to them indicates that these
numbers refer to the temperatures (Fig. G). The actual room temperature is
indicated below ROOM, while the temperature setting is indicated below SET. The
latter can be changed with the adjustment keys (refer to Section F).
G: The required tempe-
Prior to igniting the heater, always check for sufficient fuel in the removable tank.
rature on the left, the
measured temperature
4
on the right.
8