Toyotomi Zibro LC-32 Manuel D'utilisation page 18

B
fillinG fuel
Fill the removable tank in a suitable place since there can always be some
spillage. Follow the procedure below:
1 Make sure that the heater is switched off.
2 Open the upper lid and lift the removable tank out of the heater (Fig. B).
Put down the removable tank (cap pointing upwards, handle on floor) and
screw off the fuel cap (Fig. C).
NOTE: Some drops may leak from the tank.
3 Fill the removable tank using a fuel pump (refer to fuel pump operation
instructions.) Make sure that it is in a higher position than the removable tank
(Fig. D). Insert the ribbed hose into the opening of the removable tank.
4 Check the removable tank fuel gauge while filling the tank (Fig. E). Stop
filling once the gauge indicates that the tank is full. Never overfill the tank,
especially not when the fuel is very cold (fuel expands when it heats up).
5 Let the remaining fuel in the pump flow back into the jerrycan and carefully
remove the pump. Carefully screw the fuel cap back on the tank. Clean off
any spilled fuel.
6 Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
c
settinG tHe clOcK
It is only possible to set the correct time, when the heater is connected to the
mains and not burning. Use the adjustment keys N to set the time. First press
either of the two keys to switch on the function (the 4-digit K will start blinking).
Next, set the hours using the key on the left (Nhour) and the minutes using the
key on the right (Mmin.). Press once to increase the value by one step. When you
hold down the key, the value will continue going up, until you release the key
again. After approximately 10 seconds the 4-digit will stop blinking and the set-
ting will be locked (Fig. F). 5 minutes after switching off the heater, the informa-
tion on the display will disappear and the heater will automatically switch into the
stand-by position.
!
When the heater has been unplugged for more than 30 minutes (or after a
power failure), the time and the day need to be set again.
D
WeeKly tiMeR
Here is an example on how the weekly timer can be programmed:
Monday
P1 ON 6:30
P1 OFF 8:45
P2 ON 12:00
P2 OFF 14:00
18:00
P3 ON
P3 OFF 23:00
• Maximum of 3 programs per day can be set.
• Every day of the week can be programmed separately.
• Minimum switching interval, 1 hour.
• Minimum activation time, 1 hour.
• Choice between manual and timer.
• Settings are saved in the memory and remain saved without power supply.
4
6
Tuesday Wednesday Thursday
6:30 6:30 6:30
8:45 8:45 8:45
15:00 18:00 12:00
23:00 23:00 14:00
18:00
23:00
Friday Saturday Sunday
6:30 10:00 9:00
8:45 23:00 23:00
12:00
14:00
18:00
23:00
C
D
E
empty
full
F: When the 4-digit
stops blinking, the set-
ting has been locked to
the indicated value.