Complete The Installation - Bosch Dual Fuel HDI8054 Serie Manuel D'installation

Complete the installation

Adjust Leveling Legs
1. Make sure circuit breaker is off and then plug range
cord into electrical outlet.
2. Line up range in front of opening.
3. Measure (A) back left corner of opening from floor to
the top of the countertop.
4. Measure back left corner of range to bottom of cooktop
trim (B). Adjust leveling leg until this height is the same
as the corner dimension.
5. Repeat in right back corner.
6. Adjust front leveling legs so that the bottom of the
cooktop trim is ½" (12.7 mm) higher than the
corresponding countertop surface.
Slide Range into Opening
NOTICE
To avoid risk of damage to the range oven door, do
not lift, push or pull the range by holding the door
handle. Open the door and reach inside the top of
the oven cavity to locate a ridged area near the front
of the oven. Take care not to touch the oven heating
element also located at the top of the oven cavity,
just behind the ridged area.
1. Plug in power cord.
2. Dampen countertop and floor at bottom of opening with
soapy water.
3. Slide range into opening, being careful not to damage
countertops, floors, or the range door or warming
drawer front. Do not apply pressure to cooktop when
sliding into position. Be careful not to crimp the flexible
electrical connector.
Tip: Remove the range warming drawer to prevent
damage.
Check Back of range for proper Installation
1. When properly installed, the cooktop trim around the
back of the range will rest lightly on the countertop.
2. There should not be any gap between the countertop
and the trim; however, the weight of the range must not
rest on the countertop. Look under the range to verify
that both back legs are resting solidly on the floor. Also
verify that the left range leg is retained by the anti-tip
bracket.
English 16