Sony VPL-HS3 Mode D'emploi page 18

5 Adjust to correct horizontal trapezoidal
distortion using SIDE SHOT + or – .
Press SIDE SHOT + or – so that the upper side of
the picture becomes parallel to the bottom side. If
the right side is longer than the left side, press
SIDE SHOT +. If the left side is longer than the
right side, press SIDE SHOT –. To fine-adjust the
distortion, press M or m.
Note
Even when projecting using "Side Shot," four sides of a picture
may sometimes not be parallel to the sides of a screen frame.
When projecting using both "Side
Shot" (1 page 32) and "V Keystone"
(1 page 32) adjustments
When projecting using both "Side Shot" and "V
Keystone" adjustments, vertical and horizontal
distortions are corrected.
1 Set the "V Keystone" in the INSTALL
SETTING menu to "Auto."
Note
"V Keystone" in the INSTALL SETTING menu is set to
"Manual" in the default. If it is set to "Auto," the vertical distortion
of the picture will be automatically corrected. The "V Keystone"
adjustment may not correct trapezoidal distortion perfectly,
depending on the room temperature or the screen angle. In this
case, set manually by value adjustment.
18
Step 3: Adjusting the Picture Size and Position
GB
SIDE SHOT
2 Position the projector so that the picture
overlaps on the screen as shown below.
Adjust so that the vertical sides of the picture are
parallel to the vertical sides of the screen.
Check that both vertical sides of the picture are
parallel to the vertical sides of the screen.
If they are not parallel, set "V Keystone" in the
INSTALL SETTING menu to "Manual," then
press ENTER and adjust the distortion with M or
m so that they become parallel.
3 Move the projector horizontally to the left
or right so that one side of the picture fits
the inside end of the screen frame.
Adjust so that one side of the picture fits the
inside end of the screen frame.
If you position the projector on the left side of the
screen, adjust so that the left side of the picture fits
the left inside end of the screen frame. With the
projector positioned on the right side, adjust so
that the right side of the picture fits the right inside
end of the screen frame.
If the picture does not overlap on the screen,
determine and adjust the installation position of
the projector and screen referring to "Installing the
Projector and a Screen" (1 page 7).