User Manual
Remote Control
Input
1.
Press this button to instantly switch between HDMI or VGA
inputs
Exit
2.
Press this button to exit the menu or escape from the
current menu selection from within the OSD
Menu
3.
Press this button to enter the OSD menu.
Reset
4.
Press this button to set the Transmitter back to the factory
default setting.
Auto Adjust
5.
Press this button to optimise/centre the positioning of the
picture on the screen.
Enter & ▲▼◄►
6.
Press Enter to confirm a selection in the OSD, use the
arrow buttons to navigate the OSD.
Installation
Important! Before starting the installation, please ensure that all devices are powered off.
1. Connect your HDMI, VGA & Audio source equipment to the Transmitter using HDMI, VGA and
3.5mm audio cables.
2. Connect one end of the Cat.5e (max. length 80m) or Cat.6/7 cable (max. length 100m) to the
CAT.5e/6/7 Out (HDBaseT) port on the Transmitter and the other end to the CAT.5e/6/7 In
(HDBaseT) port of the HDBaseT Receiver (not included). Solid core installation cable is
recommended.
3. Use a HDMI cable to connect your HDMI display device to the HDMI output port on the HDBaseT
Receiver.
4. Plug the DC power supply into the Transmitter and switch on. If using a non 24V PoH equipped
HDBaseT Receiver please also connect the power supply for the Receiver and switch on.
5. Power on your source equipment and display then switch the Input you want to use to complete the
installation.
In addition to the basic installation steps outlined above the Transmitter can also provide the following
additional/optional functionality when used with a Receiver capable of the same features, such as LINDY
No. 38218:
10/100 Ethernet
The Transmitter and Receiver units both feature a single RJ45 port for the connection of network
equipment such as a Router, Network Switch, IP Camera, Wireless Access Point or Smart TV.
English