Publicité
Les langues disponibles
Les langues disponibles
User Manual
Back Panel
1
2
Power LED
1.
Illuminates when the Transmitter is connected to the power supply.
DC 24V
2.
Connect the power supply to this port. If using a
receiver, such as LINDY No. 38218, the receiver will not require a power supply.
RS-232 IN
3.
Connect to a PC or Laptop with a 9 Way D cable for the transmission of RS-232 commands.
LAN
4.
Connect to an internet or network connection – never connect to an HDBaseT port.
IR Blaster
5.
Connect the supplied IR Blaster Cable for IR signal transmission. Place the IR Blaster in direct line-
of-sight of the equipment to be controlled.
IR Extender
6.
Connect the supplied IR Extender cable for IR signal reception. Ensure that remote being used is
within the direct line-of-sight of the IR Extender.
CAT5e/6/7 OUT
7.
Connect to the CAT5e/6/7 IN port on the Receiver unit with a single CAT5e/6/7 cable for transmission
of all data signals – never connect to a network port. The yellow LED will illuminate to represent the
link from Receiver is stable, if it blinks irregularly it represents a link error or when not illuminated it
means no link with the Receiver. The green LED will illuminate to represent the HDMI signal contains
HDCP.
3
4
5
6
24V PoH (Power over HDBaseT) compatible
English
7
Publicité
