OPERATING INSTRUCTIONS
NOTE
Always press the trigger (F) either while
cutting completely through workpiece or while
pulling the air shear (A) back through the cut
portion of workpiece. This will help keep the
blades (C,D,E) from getting caught in the
workpiece. Release the trigger (F) only after the
air shear (A) is removed from workpiece.
NOTE
This tool features replaceable cutting
blades. Follow the steps below when replacing
cutting blades:
(1) Disconnect the air shear (A) from air supply.
(See Figure 3)
(2) Loosen the three lock screws (G) with the
provided hex key (AA) and then remove the
cutter housing (H). (See Figure 4-a & 4-b)
3
4-a
4-b
11