Topcom LF-4719 Manuel D'utilisation page 6

TOPCOM Ultrasonic Humidifier LF-4719
your home. This is why it is important to clean the
tank regularly and refill it with clean water when
you haven't been running it.
To avoid that bacteria are sprayed around in your
room, the Multifunctional Humidifier 1901W can
pre-heat the water before it is sprayed.
It will take several minutes before the mist will feel
tepid. The mist will never feel hot!
• Press the warm mist button to activate/
deactivate the this function.
• The warm mist icon
function is enabled.
6.5 Mist intensity
Press the mist intensity button
generated amount of mist. The display will
indicate the mist intensity
– 1 : low
– 2 : medium
– 3 : high
6.6 Ionizer (Ozone)
The air ioniser is a device which uses high voltage
to ionise, or electrically negative charge,
molecules of air. Negative ions (Ozone) help
freshen and purify bad particles in the air, which
are causing allergens such as pollen, mold
spores, dust, and animal dander floating in the air
. They help to lift mood, alleviate depression and
seasonal affective disorder and promote a sense
of well-being.
When the Humidifier is on:
• Press the Ozone button
deactivate the ioniser.
• The Ozone icon
k
function is activated
6.7 Timer
• Press the Timer button
change the timer from 1 to 12 hours in steps
per hour.
• The time is displayed
When the Timer is elapsed, the
humidifier automatically stops.
The humidifier will also stop, when
the set Humidity level is reached.
6.8 Room temperature
The temperature indication
display the room temperature when the humidifier
is switched on.
6
g
is displayed when the
to change the
f
:
o
to activate/
e
is displayed when the
to alternatively
h
m .
in the display will
n
7 Cleaning
7.1 Water tank
• Drop a few drops of detergent into the water
tank .
• Fill it half with water and shake it up and down
several times.
• Remove the dirty water and use clean water to
rinse the box.
7.2 Water flume
If there is waste left in the water flume, use a soft
cloth to clean it.
7.3 Transducer
When you use hard water, there will be some lime
scale left on the transducer
Use white vinegar and a brush tool to clean the
transducer. Use fresh water to rinse the remains.
7.4 Filter
The filter on water cap
These ceramic balls will soften hard water and
can eliminate the strange smell in the water.
Clean the filter after approximately 600 liters of
water has been used (100 full tanks of water).
• Unscrew the filter from the water cap
• Put the filter in white vinegar for approximately
15 minutes.
• Take it out of the vinegar and shake it several
times.
• Rinse it with fresh water.
• Screw the filter back on the cap
.
contains ceramic balls.