Connection To An Audio System - Funai Electric Magnavox H2080MW8 Manuel D'utilisation

CONNECTION TO AN AUDIO SYSTEM

• When you change the connections, all devices should be turned off.
• Refer to the manual accompanying external devices for more information.
2 Channel Analog Audio Connection
stereo system
VIDEO
OUT
VIDEO VIDEO
IN OUT
IN
L L
OUT
R R
IN OUT
PR/CR COAXIAL
AUDIO IN COMPONENT DIGITAL AUDIO OUTPUT
ANTENNA S-VIDEO AUDIO OUT S-VIDEO
( E1 ) VIDEO OUT PCM/BITSTREAM
AUDIO OUT
Supplied cables used in this connection are as follows:
• RCA audio cable (L/R) x 1
Please purchase the rest of the necessary cables at your local store.
Connection
If output is Dolby Digital encoded audio, connect to a Dolby
Digital decoder.
Connecting to an MD deck or DAT deck.
If not connected to any external devices.
* To complete these settings, refer to page 98.
Note
• The audio source on a disc in a Dolby Digital multi channel surround format cannot be recorded as digital sound
by an MD or DAT deck.
• By connecting this unit to a Dolby Digital decoder, you can enjoy high-quality Dolby Digital multi channel
surround sound as heard in the movie theaters.
• Playing back a DVD using incorrect settings may generate noise distortion and may also damage the speakers.
AUDIO IN
R L
analog audio
input jacks
RCA audio cable
L L
R R
AUDIO OUT AUDIO OUT
Digital Audio Connection
Dolby Digital decoder, MD deck or DAT deck
audio
digital audio coaxial input
digital audio coaxial cable
this unit
VIDEO VIDEO
Y
IN OUT
IN
PB/CB
L L
OUT
R R
IN PR/CR OUT
AUDIO IN
ANTENNA COMPONENT
S-VIDEO AUDIO OUT S-VIDEO
( E1 ) VIDEO OUT
DIGITAL AUDIO OUTPUT
Setting Setup >General Setting >Playback >Disc Audio >
COAXIAL
jack
COAXIAL
DIGITAL AUDIO OUTPUT COAXIAL
PCM/BITSTREAM
DIGITAL AUDIO OUTPUT
PCM/BITSTREAM
Dolby Digital
Stream
PCM
PCM
EN EN 19 19