Connecting The Water Line; Before Beginning - LG LRFDS3006 Serie Manuel Du Propriétaire

20 INSTALLATION
4
Push the water supply lines into the hole on
the top case and pull it through the backplate.
5
Hold the water supply connection and gently
push in the collet to connect the water
d
supply line as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tube in place.
NOTE
• Disassembling/Assembling the Water Lines
Collet Tube Insert line
e f g
• Gently press the collet and insert the tube until
only one line shows on the tube.
Assembling the Hinge Cover
Position the hinge cover in its place. Insert and
tighten the cover screws.

Connecting the Water Line

Before Beginning

This water line installation is not covered by the
refrigerator warranty. Follow these instructions
carefully to minimize the risk of expensive water
damage.
If necessary, call a qualified plumber to correct
water hammer before installing the water supply
line to the refrigerator. Water banging in the
pipes, or water hammer in residential plumbing
can cause damage to refrigerator parts and lead to
water leakage or flooding.
• Turn the icemaker OFF if the refrigerator will be
used before the water line is connected.
• Do not install the icemaker tubing in areas
where the ambient temperatures fall below
freezing.
• Connect to potable water supply only.
Clip
h
• To prevent burns and product damage, only
connect the refrigerator water line to a cold
water supply.
• Wear eye protection during installation to
prevent injury.
WARNING
CAUTION