Makita BO4566 Manuel D'instruction page 5

1. Set the tool upside down so that the pad is on top.
2. Position the sandpaper to fit the shape of the
base. Be sure to align the holes on the sandpaper
with the holes on the pad (the dust will be sucked
into these holes; it is therefore important to leave
them open).
3. Press the paper firmly over the pad.
To remove the sandpaper:
1. Set the tool upside down so that the sandpaper is
on top.
2. Grasping one corner of the sandpaper, peel it
from the pad.
NOTE:
If the sandpaper is in good condition, save it for
•
further use.
When sanding in narrow, hard-to-reach areas (e.g.,
shutters, blinds, louvers), attach the cone-shaped
abrasive papers to the end of the pad (bottom and top).
To sand the end of thin materials, fold the abrasive
paper and attach to the side of the pad as shown in the
figures.
Dust bag
008301
The use of the dust bag makes sanding operations
clean and dust collection easy. To attach the dust bag,
fit the bag's entry port onto the dust spout on the tool.
Make sure that the hole in the bag's entry port is just
over the pimple-like protrusion on the dust spout.
For the best results, empty the dust bag when it
becomes approximately half full, tapping it lightly to
remove as much dust as possible.
Installing paper dust bag (optional accessory)
2
1
3
003742
1. Dust bag
1
1. Groove
2. Front fixing
cardboard
3. Front side of
paper dust bag
Place the paper dust bag on the paper dust bag holder
with its front side upward. Insert the front fixing
cardboard of the paper dust bag into the groove of the
paper dust bag holder.
Then press the upper part of the front fixing cardboard
in arrow direction to hook it onto the claws.
1
003743
Insert the notch of the paper dust bag into the guide of
the paper dust bag holder. Then install the paper dust
bag holder set on the tool.
1
003744
003745
OPERATION
Sanding operation
008319
5
1. Claws
2. Upper part
2
1. Notch
2. Guide
2