Trouble Shooting; Maintenance And Cleaning - CROMAKIT RSLAB-7 Manuel D'utilisation

Junio 2011

8- Trouble shooting

The instrument doesn't work:
The speed cannot reach set value:
The motor does not start via pressing the speed knob and time knob:

9- Maintenance and cleaning

Use and maintain the instrument in right way to keep it in good operating state in order to lengthen its
life time and avoid the damage to the instrument. Only use the cleaning agents which have been
approved by manufacturer to clean the instrument.
Only use cleanser that we advised as below:
- Dyes: Isopropyl alcohol
- Construction materials: Water containing tenside / isopropyl alcohol
- Cosmetics: Water containing tenside /isopropyl alcohol
- Foodstuffs: Water containing tenside
- Fuels: Water containing tenside
For materials which are not listed, please request information from your supplier. Before using another
than the recommended method for cleaning or decontamination, the user must ascertain that this
method does not destroy the instrument. Wear the proper protective gloves during cleaning of the
instrument.
No sumergir el aparato eléctrico en el producto durante su limpieza.
Electrical instrument may not be placed in the cleansing agent for the purpose of cleaning. The
instrument must be cleaned and put it into the initial packaging carton before sending to service for
repair, avoiding the contamination of hazardous.
The equipment should be clean before sending to the distributor for repair.
Switch OFF the instrument and put it in the dry, clean, stable place at room temperature in long-term
disuse.
10- Regualtions
Construction in accordance with the following safety standards:
EN61010-1
UL3101-1
CAN/CAS C22.2(1010-1)
EN 61010-2-10
Construction in accordance with the following EMC standards:
EN61326-1
- Check whether the power cable fitted well
- Check whether the fuse is broken
- Check whether it is overloaded.
- Check whether the time is set to zero.
- 7 -