Set Time; Setting Speed; Operating Modes; Mode A - CROMAKIT RSLAB-7 Manuel D'utilisation

Junio 2011
Items
Speed Knob
Time Knob
Shaking table
LCD Speed / LCD Time
Put the instrument on stable and safe place and plug in the mains power.
Turn ON the mains switch on the left panel. The instrument starts self-test. The instrument shows rated
speed and time after initialization..
Turn the speed knob on the left side to set the rated speed.Press the speed knob and characters on the
left LCD do not flash any more, and the shaking function is switched ON.Press the speed knob again
and characters on the left LCD begin to flash, and the shaking function is switched OFF.
Turn the time knob on the left side to set the rated time. Press the time knob and characters on the
LCD do not flash any more, and the timing function is switched ON. Press the time knob again and
characters on the right LCD begin to flash, and the timing function is switched OFF..
b. Set time
The equipment can work in continuous mode or time/continuous (max. 19h59m). The setting of the
work time is made through the control in the right side. In case the equipment turns off and on again,
the setting disappears. During the process of running at the time and speed set up, the user can
activate these two functions through the regulation controls, as indicate below:
- Pressing the time knob，the speed and the time will stop. Pressing the time knob again, restart the
shake function, the time will use the pre-set time.
- Pressing the speed knob，the speed and the time will stop; Pressing the time knob again, restart
the shake function, the time not(There are flashing on the right of the LCD )，pressing the time knob
again restart the time function. The time will use the pre-set time..
c.

Setting speed

User can set and increase the shaking speed by turning the regulation control.
The continuous mode is activated pressing the control on the left without time setting. The shaking
stops pressing again this control.
Increasing the shaking speed by turning the control progressively in order to avoid shocks in the
equipment.
Shaking speed can be modified at any momento.

6- Operating modes

a.

Mode A

Operating mode A is the default mode set in factory.
After turning ON the instrument with the mains switch, the shaking and timing functions are turned
OFF. The LCD displays the set time and speed values. They are adopted or varied when the
corresponding functions are turned ON.
After turning ON the instrument, the following process will be shown on the display:
The left LCD displays "SAF" and the right displays the upper speed limit (rpm）which can be set by
pressing the speed knob and turning at the same time.
Decription
Set the rated rotary speed. "rotation" is switched ON or OFF via
pressing the knob.
Set working time. "rotation" is switched ON or OFF via pressing
Plato de agitación para los recipientes
Set working time. "rotation" is switched ON or OFF via pressing
- 5 -
the knob
b
the kno