VWR VisiScope 400 Serie Manuel D'utilisation page 6

Installing the stage extension and the mechanical stage
The stage extension can be installed on either side of the stage to enlarge the working surface. The mechani-
cal stage must be installed on the side opposite the extension. The stage extension can be installed on either
side of the stage to enlarge the working surface. The mechanical stage must be installed on the side opposite
the extension.
For right-handed operators, the mechanical stage is normally installed on the right side.
1. Installing the stage extension: Screw the bolts (1) on to the extension, then mount the extension from
below the stage. Screw it to a firm fit.
2. Installing the mechanical stage: As for the extension, the mechanical stage is fixed by two bolts under the
stage.
Installing the stage insert
1. When using the glass stage (1), make sure that the stage is horizontal.
2. Install the stage insert in the stage opening.
Turn the disk until the V-groove faces the user. This simplifies objective identification.
Installing the eyepieces
1. Remove the cap of the eyepiece tubes (1).
2. Insert the eyepieces (2) into the tubes.
Heruntergeladen von manualslib.de
1
2
Handbücher-Suchmachiene
1
1
6