Transport, Storage And Operating Conditions - bock SR2 Instructions De Montage Et D'utilisation

The side rail SR2 is now in the lowered position.
To move the side rail SR2 to the upper position, grap
the upper side rail with one hand and pull the side
guard rail upwards into the upper position, the re-
lease button clicks audibly into place. The side rail
SR2 is now in a pulled-up position.
Please note the increased risk of trapping caused by the raised side rails when adjusting the
When using different mattress thicknesses, the minimum height must not be below 22
cm, measured from the upper edge of the side rails above the mattress, without compres-
sion.
Therefore, the following measurements must be observed for safe use of the side rails:
Height above the mattress: ≥ 220mm


Gap dimensions between bars and to the lying surface: <120mm

Gap dimensions between side rail and end piece: <60mm or >318mm
2.8

Transport, storage and operating conditions

Temperature
Relative humidity
Air pressure
Hazard note from Bock
backrest and upper leg rest.
Transport and storage
0°C to +40°C
20% to 80%
12
10°C to +40°C
800hPa to 1060hPA
EN
Operation
20% to 70%