Dogtra YS 500 Manuel D'instructions page 24

TESTING ANTI-BARK COLLAR
1) Turn on the "Anti-bark collar" by turning the
intensity dial clockwise and set it on level
seven.
2) Fit the test tool on the sensor of the collar.
3) Test by scratching the rough surface of the test
tool on the collar (as shown in the diagram)
using a coin. When the light comes on, wait for
4 seconds, then repeat the same process once
more.
44
SELECTING ON-OFF & INTENSITY LEVELS
SELECTING ON-OFF &
INTENSITY LEVELS
1. The dial on the collar is used to turn the "Anti-
bark collar" on and off and for selecting the
intensity level.
2. To turn off the "Anti-bark collar", position as
shown above.
( )
Decrease
3. Level 1 is lowest and 7 is the highest.
4. By turning the ON/OFF dial clockwise with
your thumbnail, stimulation intensity increases
and by turning counter-clockwise, it decreases.
(+)
Increase
45