GE Appliances Cafe CFE Serie Manuel D'utilisation Et D'installation page 42

Troubleshooting Tips... Before you call for service
Problem
PRECISE FILL will not fill container
Photos not found
cooling
Hot water does not work
Hot water continues to dispense for
a short time after releasing the knob
Low brewing flow rate
from inner door
Brewer stuck in the door bracket
Brewer is not detected by the
screen menu or hot water leaking
from top of the brewer
Coffee dispensed with splash or
bubble bursting
Beverage quality not as expected
Liquid drips from the brewer after
brewer cycle is completed and the
brewer is removed from the bracket
*Some models do not come equipped with the filter bypass plug. To obtain a free bypass plug, call 800-GECARES.
42
Possible Causes
Normal, PRECISE FILL requires use
of dispenser paddle
Photos not in JPEG format
Normal, when refrigerator first plugged
in or after extended power outage
Normal
Operation disabled
Low water pressure
Water supply line turned off or not
connected
plug not installed
Water filter is partially clogged or low
door if it remains closed for a long
duration
unseated and interfering with
articulating mullion operation
There may have been a dent at the
to pierce the filter allowing coffee
grounds clogging the bottom pin
Top needle of the brewer clogged
mode instead of brew mode while the
brew module is installed
bracket
Blocked vent hole in the brewer
You may be using non-standard or out
by the brewer and drip when it is
removed
What to Do
PRECISE FILL to dispense water
Make sure the photos are in the root
Photos must be in JPEG format
Wait 24 hours for temperature in both
compartments to reach selected
temperatures.
The ice dispenser door may open
access
not selected
Make sure water line is not kinked
Replace filter cartridge or remove
filter and install bypass plug*
Replace filter cartridge or remove
filter and install bypass plug* or
increase water pressure
Reseat the gasket all the way in the
groove
and clean the lower needle before
next brew
paper clip and rinse brewer. Rinse
brewer after every use.
Cancel hot water dispense mode so
hot water tube will retract from the
brew module
front. Push brewer all the way in the
brackets
Make sure the vent hole at the
bottom of the brewer is clear from
food or any other contamination
and have not been damaged
the drips when brewer is removed
49-60791-2