GE Appliances Cafe CFE Serie Manuel D'utilisation Et D'installation page 28

Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
REMOVE THE REFRIGERATOR
3
DOORS (cont)
Note: for proper installation later, please follow
the next step carefully.
F
INSTALLED opened at 90° with case front.
Lift up & off
center hinge
REMOVE OPPOSITE DOOR
door. There are no wires or water lines on the
opposite side
REMOVE CENTER HINGE
4
(if necessary)
Remove
center screw
Loosen Outer screws
28
REMOVED and
90°
REINSTALLING THE
5
REFRIGERATOR DOORS
Reverse steps 1 through 4 to reinstall refrigerator,
follow details below for critical alignments.
Reinstall center hinge
A
first and torque the
screws to 65 in-lb (7.34
N-m). With the LH door
at 90º to the front of the
case, lower the refrigerator
door onto the center hinge.
Ensure that the door and hinge align correctly.
B
Rotate doors closed and make sure moveable
center sealing portion of the door aligns with
reinstalling, remove door, turn door upside down,
corresponds to an alignment mark on the bottom
end cap. Rotate door closure mechanism to align
align marks
If door cannot be installed at 90° follow steps below:
underside of door. The flats on the shaft should
correspond to alignment tab on plastic ring or mark
on bottom end cap.
wrench, rotate door closure mechanism shaft
counterclockwise for right door and clockwise for left
Securely tape the door shut with masking tape
or have a second person support the door.
Reinstall the top hinge and torque the screws to
65 in-lb (7.34 N-m).
C Be sure to reinstall the ground wire and strain relief
to the top hinge.
Reinstall the hinge cover. Note: Ensure wires
are not pinched or under screw bosses before
tightening screws.
49-60791-2