Installing The Batteries - Schon 67558-0101 Guide D'utilisation Et D'entretien

Installation (continued)
9
Installing the data cable
□
Install the data cable (1) to the corresponding
push t connection (2) on top of the control
box (O). Ensure that the data cable (1) is fully
inserted and secure it by tightening the nut (3)
by hand in a clockwise direction.
10

Installing the batteries

□
Squeeze the side indicated by the arrows (5) below on the battery pack (P) and then pull down to remove
the cover (1).
□
Install four AA batteries (2), make sure the end of "+" on the batteries (2) matches the ends (3) in the
battery pack (P) and the end of "-" on the batteries (2) is matching the ends (4) in the battery pack (P).
□
Reinstall the battery pack cover (1) by pushing up into place.
NOTE: When the sensor ashes 10 times continuously
and slowly, the batteries have lost their charge. Replace
the batteries (2).
5
5
P
1
O
P
P
4
1
8
1
3
3
4
2
2
1