Bostitch BCN662 Manuel D'instructions page 16

English
SYMPTOM CAUSE
Tool operates, but no fastener No nails in magazine
is driven
Wrong size or angle nails
Debris in nosepiece
Debris in magazine
Worn magazine
Damaged or worn driver blade
Damaged pusher spring
Jammed nail Wrong size or angle nails
Magazine screws not secured after previous
jam clear/inspection
Damaged or worn driver blade
Material and fastener length
Debris in nosepiece
Worn magazine
Damaged pusher spring
14
FIX
Load nails in magazine.
Use only the recommended nails Refer to Nail Specifications.
Clean nose area and watch closely for small pieces of broken nails stuck
in the track.
Clean magazine
Replace magazine See authorized service center.
Replace driver blade See authorized service center.
Replace spring; see authorized service center.
Use only the recommended nails Refer to Nail Specifications.
Make sure to tighten magazine hex bolts with wrench provided.
Replace driver blade See authorized service center.
If the unit continues to stall (forcing the need to rotate the Stall release
lever) choose the appropriate material and fastener length that is not too
rigorous an application.
Clean nose area and watch closely for small pieces of broken nails stuck
in the track.
Replace magazine See authorized service center.
Replace spring; see authorized service center.