Saber Select R42SC0321 Guide page 8

Ignitor Lighting
• Do not lean over grill while lighting.
1.
Turn gas burner control valves to
2.
Open lid during lighting or re-lighting.
3.
Turn ON gas at LP cylinder.
4.
To ignite, push and turn burner knob to
ELECTRONIC IGNITOR button until the burner lights.
5.
If ignition does NOT occur in 5 seconds, turn the burner controls off
5 minutes and repeat the lighting procedure.
6.
Repeat steps 4 and 5 to light other main burners.
WARNING
Turn controls and gas source or tank OFF when not in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the burner controls
minutes and repeat the lighting procedure. If the burner does not ignite with the
valve open, gas will continue to flow out of the burner and could accidently ignite
with risk of injury.
Match-Lighting
Do not lean over grill while lighting.
•
1.
Turn gas burner control valves to
2.
Open lid during lighting or re-lighting.
3.
Turn ON gas at LP cylinder.
4.
Place match into match holder (hanging from side panel of grill). Light match;
then light burner by placing match through the match light hole on side of grill.
Immediately push in and turn burner knob to the
burner lights and stays lit.
5.
Light adjacent burners in sequence by pushing knobs in and turning to the
HIGH position.
USE AND CARE
(off).
HIGH. Immediately, push and hold
, wait
off, wait 5
(off).
HIGH position. Be sure
Putting out grease fires by closing the lid is not possible. Grills are well
•
ventilated for safety reasons.
Do not use water on a grease fire. Personal injury may result. If a grease fire
•
develops, turn knobs and LP cylinder off.
• Do not leave grill unattended while preheating or burning off food residue on HI.
If grill has not been regularly cleaned, a grease fire can occur that may damage
the product.
Pa g e 8
CAUTION
S A B E R G R I L LS . C O M