Replacing The Ear Pads; Precautions - Sony MDR-IF420RK Mode D'emploi

Replacing the ear
pads
When the ear pads become dirty or
damaged, you can get replacements
from your Sony dealer. Replace them
as illustrated below.
1
Remove the old ear pad by pulling
it out of the groove on the housing.
2
Place the new ear pad on the
housing and insert the edge of the
pad onto the groove as illustrated.
Make sure that the entire edge of the
ear pad is securely inserted into the
groove.
12
( Additional information

Precautions

• The CE mark on the unit is valid only
for products marketed in the
European Union.
• When the transmitter is not to be
used for a long period of time,
disconnect the AC power adaptor
from the AC outlet holding the plug.
Do not pull on the cord.
• Do not leave the cordless stereo
headphones system in a location
subject to direct sunlight, heat or
moisture.
Notes on headphones
Preventing hearing damage
Avoid using headphones at high
volume. Hearing experts advise
against continuous, loud and extended
play. If you experience a ringing in
your ears, reduce the volume or
discontinue use.
Caring for others
Keep the volume at a moderate level.
This will allow you to hear outside
sounds and to be considerate to the
people around you.
If you have any questions or problems
concerning the system that are not
covered in this manual, please consult
the nearest Sony dealer.
Be sure to bring the headphones and
the transmitter to the Sony dealer when
requiring repair work.