Drive Casalift 140E Manuel D'utilisation page 36

Foreword Maintenance and inspection
Introduction Maintenance – Annually
1 Foreword
Description
Component
1.1 Introduction
Support bracket
The Casalift 140E / 180E is a lightweight and versatile lift device for use in patient
and geriatric care situations. Use of the lift is facilitated considerably by its
spreading travel leg design. After use, or for transport by car, it can be disman-
Chassis
tled.
This manual was produced based upon the information available on the design
and operation of the Casalift which was available at time of printing. We reserve
the right to make changes due to technical advances.
Should you have any questions concerning the Casalift, please contact your spe-
Stress test 140.0 kg (Casalift 140E)
cialist Days Healthcare dealer (see dealer's stamp on the back of the envelope).
Stress test 180.0 kg (Casalift 180E)
Perform metrological control (see page 34)
1.2 Intended use
The Casalift 140E / 180E should be use exclusively for the purpose of lifting and
11.2.4 Metrological control
moving persons in need of care. It is only designed to move patients over short
In some countries of the European Union, the following list of measurements are
distances.
prescribed by law (in Germany according to BGV A3).
Improper use will lead to the exclusion of the manufacturer's liability.
It is the responsibility of the owner of the Casalift to determine the situation in
The Casalift may only be used by persons who have received instruction from the
their particular country.
owner, and under consideration of the condition of the patient being transport-
The following measurements may only be made by trained and experienced per-
ed. In borderline cases, or if in doubt, consult the attending doctor.
sonnel using appropriate measuring instruments. Any defects which are estab-
lished must be notified immediately to the appropriate parties and rectified.
Restriction on use!
Patients who are heavier than 140 kg/180 kg must not be lifted with the Casalift.
Description
1.3 Information on the operating manual
The following measurements must be made acc. to DIN VDE
0751:
1.3.1 Symbols used in the operating manual
Alternative leakage currents
The following symbols are used in the operating manual to identify particular
hazards in using the product or information to simplify usage.
Information on measuring the alternative leakage currents:
Caution!
Typical value:
This symbol identifies safety instructions which highlight risks in using the prod-
uct.
Inspection point:
Caution!
This symbol identifies safety instructions which highlight risks of crushing and
trapping when using the product.
GB – 20 GB – 34
Inspection type
Visual inspection of welds
No damage
Connection to boom
Visual inspection of welds
No damage
Castors undamaged
Function of the brakes
< 20 µA
Short-circuited mains plug (L+N) to bare, metallic points on
the frame of the charging station (screws, etc.)
Evaluation
OK
Evaluation
OK
Casalift 140E / 180E – 15.10.2010 Casalift 140E / 180E – 15.10.2010
Defective
Defective