ASSEMBLY INSTRUCTIONS
b. To lower the handle assembly:
•
Open the upper cam locks (AA).
Note: If the handle lock is difficult to open, loosen
the knobs on the upper handle locks by turning them
counterclockwise.
•
Lower the upper handle.
•
Open the lower handle lock (J).
•
Push outward on each side of the lower handle until it
is free from the slot. Then, fold the handle to the front
of the unit. Avoid pinching or trapping any cables.
2. Installing the mulching plug
(for mulching operation)
Note: When using the mulching plug (B), do not install
the grass catcher.
•
Remove battery.
•
Lift and hold the rear discharge cover (K).
•
Grasp the mulching plug (B) by its handle and insert it
at a slight angle.
•
Push the mulching plug (B) securely into place.
•
Lower the rear discharge cover.
•
Reinstall battery when you are ready to mow.
3. Installing the grass catcher
(for rear bagging operation)
Note: When using the grass catcher (C), do not install
the mulching plug.
•
Remove battery.
•
Lift the rear discharge cover (K).
•
Lift the grass catcher (C) by its handle and place under
the rear discharge cover (K) so that the hooks on the
grass catcher are seated onto the slots on the mower
housing.
•
Release the rear discharge cover (K).
•
Reinstall battery when you are ready to mow.
1b
2
B
3
C
14
J
K
K