Conditions For Installation; Important; Electromagnetic Compatibility (Emc) - TecniWork PODOSCOPIO AP500 Manuel D'instructions

1- Unpack the podoscope completely.
2- Disposal of packing elements (plastic foams, polystyrene, polyethylene, cardboard) must follow your local
waste disposal guidelines.
3- Verify that the podoscope has not been damaged during transport. In case, please contact the manufacturer
immediately.
IMPORTANT: Please take notice of the fact that light stripes and/or microscopic luminescent dots on the transparent
surface of the podoscope are due to the particular nature of its material and do not impair the equipment functionality.
RIGHT POSITIONING AND SAFETY INSTALLATION OF THE PODOSCOPE
Position the podoscope so as to leave enough room around it to be able to safely operate and to connect and
disconnect easily the device to the power supply network.
We suggest to attach a handle on the wall as indicated in the scheme below to make easier for patients to go on
and down the podoscope.
Handle
130 cm
51.19 in
ELECTROMAGNETIC COMPATIBILITY (EMC)
The podoscope needs special precautions concerning electromagnetic compatibility (EMC) and must be installed
and operated according to the EMC information contained in this manual.
In order to avoid possible risks of electromagnetic interferences, do not use radio frequence portable or mobile
devices near the podoscope.
Generally the podoscope should not be used near or together other equipements; in the case this would not be
possible, it's necessary to observe its operativity to verify the normal functioning.
TECNIWORK S.p.A. - PODOSCOPE AP500
PodoManISTRUZ_A4_x.indd 19
2.2 CONDITIONS FOR INSTALLATION
100 cm - 39.4 in
Handle
Podoscope
15 cm
5.9 in
- 19 -
GB
120 cm - 47.25 in
doc.cod.IS-05-2 Ed.23/11/16
05/01/17 13:10