Electrical Features And Voltage; Components Identification - TecniWork PODOSCOPIO AP500 Manuel D'instructions

Electric isolation and well-balanced distances between the surfaces avoid the formation of electric arches.
In addition to this, the podoscope has a solid mechanical structure and an excellent stability on the ground.
It has no sharp edges, therefore there exists no danger of mechanical nature both for operators and patients.
Each part of the inner circuits are assembled and fixed in such a solid way so as to stand up to the often ad-
verse transport conditions.
As to indirect shocks, the device is classified in Class II.
As to current leakage it can be classified in class B.
No essential performance is defined for this device.
1.5 ELECTRICAL FEATURES OF THE PODOSCOPE
The conventional led power supply functions with single-phase current (220-240 V - 50/60 Hz); the mark is ILC NanoLED.
The power cord - H05VV-F - 2 mt (6.56 ft) long, section 2 x 0.75 bears the mark IMQ, has a two-pole plug and it is con-
nected to the podoscope through a connector.
The internal connectors of the power cord satisfy the norm CEI 20-20 (type H05V).
PODOSCOPE AP 500
1- Transparent methacrylate surface
2- Basement in ABS (acrylonitrile butadiene
styrene with wiring)
3- Mirror
1
2
TECNIWORK S.p.A. - PODOSCOPE AP500
PodoManISTRUZ_A4_x.indd 17
1.6 COMPONENTS IDENTIFICATION
3 3
7 7 7
- 17 -
4- Power cord jack
5- On/Off switch
6- Fuse holder
7- Identifi cation plate
6 6
4 4 4 5 5 5
doc.cod.IS-05-2 Ed.23/11/16
05/01/17 13:10
GB