BRASSELER USA BRiO440 Mode D'emploi page 10

Cleaning Water Spray Ports
Note: It is recommended that spray ports be periodically cleaned.
1. Carefully clean ports using cleaning wire supplied with handpiece (Fig. 9).
2. Connect handpiece and run with water flow activated to confirm ports have been fully cleared of debris.
3. Repeat steps 1 and 2 as necessary.
Fig. 9
Cleaning Optic Rod
1. Clear optic surfaces of particulates by spraying with air syringe.
2. Wipe optic surfaces with a soft cloth or cotton swab moist with alcohol.
STERILIZATION
WARNING
• Sterilize with autoclave after each patient use.
• Sterilization is required before first use.
10 EN