Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. SETUP
Pump Rear View
1.
Remove the control unit from the box, and check for any obvious damage. If damage is evident,
notify your authorized distributor.
2.
Place pump on a horizontal surface or hang the pump on the foot board of the bed frame with
built-in hanger on back of pump.
3.
Remove mattress from protective plastic cover and check mattress surface for tears or cracking.
Do not use if any damage presents. Notify your authorized distributor of the damages.
Connect pump hoses to mattress – connect the main connection tube of the mattress to the
4.
connector on the side of the control panel.
Make sure the connection hose engages properly.
Ensure all air tubing are not kinked and will not be pinched by any articulated bed
mechanisms.
Check if the CPR valve is set to "CLOSE" position.
5.
Plug pump into a properly grounded wall output. Verify power to this outlet is not controlled
by a wall switch.
Hanger
Power Switch
Pump Front View
4
Publicité
Table des Matières
