Installing/Removing The Battery Pack - Ego Power+ LB5800E Manuel De L'opérateur

APPLICATION
You may use this product for the purposes listed below:
◾
Clearing hard surfaces such as driveways and
walkways.
◾
Keeping decks and driveways free from leaves and
pine needles.
NOTICE:
The tool is to be used only for its prescribed
purpose. Any other use is deemed to be a case of misuse.
ASSEMBLING/REMOVING THE BLOWER TUBE
◾
To Assemble (Fig. B & C)
Align the groove and push the tube onto the blower
housing until you hear a "click".
◾
To Remove (Fig. D)
Press the tube-release button and pull the tube out.
ASSEMBLING/REMOVING THE BLOWER ROUND/FLAT
NOZZLE
◾
To Assemble(Fig. E & F)
Align the groove in the round nozzle with the tube knob
and push the nozzle onto the tube until it snaps into
place.
◾
To Remove(Fig. G)
Press and hold the nozzle-release button to disengage
the latch, then pull the nozzle straight from the blower.
NOTICE:
Follow the same sequence to assemble or
remove the flat nozzle.

INSTALLING/REMOVING THE BATTERY PACK

Charge before first use.
Use only with battery packs and chargers listed
in fig.A
◾
To Install (Fig. H)
Align the battery ribs with the mounting slots and press
the battery pack down until you hear a "click".
◾
To Remove (Fig. I)
Depress the battery-release button and pull the battery
pack out.
WARNING:
Always take care to note the location of
your feet, children, or pets when pressing the battery-
release button. Serious injury could result if the battery
pack falls. NEVER remove the battery pack when in a high
location.
Fig. H parts description see below:
H-1 Battery-Release Button H-3 Mounting Slot
H-2 Battery Rib
STARTING/STOPPING THE BLOWER (Fig. J)
◾
Air-Speed Trigger Only
1. Depress the air-speed trigger to turn on the blower.
2. The air speed of the blower is controlled with the
variable speed trigger. More pressure on the trigger
results in higher blowing speeds; less pressure on
the trigger results in lower blowing speeds. Adjust the
speed to suit the task at hand.
3. Release the air-speed trigger to turn off the blower.
◾
Speed/Lock-On Dial Only
The blower can be turned on and locked at any speed
with the speed /lock-on dial.
1. Turn the speed/lock-on dial clockwise to start the
blower. The air speed will increase as the dial is rotated
clockwise.
2. To decrease the air speed, turn the speed/lock-on dial
counterclockwise.
3. Keep turning the speed/lock-on dial counterclockwise
to the off position to stop the blower.
NOTICE:
If the speed/lock-on dial is not turned back to
the off position before turning the blower on, the blower
will not start through the speed/lock-on dial when a
charged battery is installed. This is a protection feature
to help prevent accidental startup. Depress the air-speed
trigger can deactivate the protection.
Press the boost button while working to temporarily increase
the air speed to the maximum level. The blower will resume
the previous speed when the boost button is released.
Fig. J parts description see below:
J-1 Speed/lock-on Dial
J-2 Boost Button
Tips For Using The Blower
◾
To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the
center of a pile.
◾
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
56 VOLT LITHIUM-ION CORDLESS BLOWER — LB5800E
EN
J-3 Air-speed Trigger
9