Tape Operation
Search System
For each recording, an invisible index
mark is placed on the tape. A program
index and information are also included
for timer recordings. These marks are
used to access or scan recordings.
Index Search
1
Press SEARCH*
INDEX SEARCH
to display SEARCH
ENTER INDEX NUMBER :1
USING 1- 9 KEYS
in Stop or Play
FORWARD SEARCH :FF
mode, and then
REVERSE SEARCH :REW
press NUMBER
EXIT
:SEARCH
keys to select
recording number.
• To calculate
Press FF/SLOW+
or REW/SLOW- on
the remote to start
search.
2
Play begins at
INDEX SEARCH
search end.
To search forward
or back 1 index,
press FF/SLOW+ or
FORWARD SEARCH : FF
REVERSE SEARCH : REW
REW/SLOW- on the
remote while
screen left is
displayed (10 sec.).
• To cancel, press
To Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
1
2
3
4
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
1
2
3
4
NOTE:
indicates start points of each recording.
Note
• If Index Search is started very close to an
index mark, that index mark may not be
counted in the search.
30
D4744S-K P26-35 (040202).p65
Zero Search
To quickly return to a specified tape location.
1
Press DISPLAY during play
to display Counter.
2
PLAY
3
Continue to record, playback etc.
4
number, see below.
Press STOP.
5
REW
STOP
• DECK will go into FF or REW mode and
stop at the last point the Counter was set
to 0:00:00.
Commercial Skip
DECK fast forwards (skips) over 1, 2, or 3
PLAY or STOP.
minutes of recorded tape as desired.
1
Press CM/ZERO in Play mode.
• The skip time can be changed by
pressing CM/ZERO repeatedly as shown
by the figure below.
5
6
7
5
6
7
• No indication appears on-screen.
30
Press COUNTER
1 2 : 0 0AM
0 : 0 0 : 0 0
RESET on remote at
SP
desired position to
reset to "0:00:00".
Press CM/ZERO
1 2 : 3 0AM
CH 02
0 : 30 : 30
SP
in Stop mode to start
Zero Search.
1 2 : 3 1AM
CH 02
0 : 0 0 : 0 0
SP
PLAY
1st Press
1 min Skip
2nd Press
2 min Skip
3rd Press
3 min Skip
2004/02/02, 15:10