Connections
Basic Connections
If your TV has AUDIO and VIDEO IN terminals, connect them to DECK for higher
•
quality picture and sound.
You can enjoy stereo sound even if your TV is not stereo by connecting a stereo
•
amplifier to DECK.
• Connect DECK and TV with an RF Coaxial Cable
(not supplied) as shown in the figure below.
I I I I I DSS Receiver
DECK
DSS
Receiver
IN
DVD/VCR DECK
IN 1
OUT
VIDEO
L
AUDIO
R
When using "Nut type" RF coaxial cables, tighten with
fingers only. Overtightening may damage terminals.
Note to CABLE system installer
This reminder is provided to call the CABLE system installer's attention to Article 820-40 of the
NEC in USA (and to the Canadian Electrical Code in Canada) that provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be connected to the grounding
system of the building, as close to the point of cable entry as practical.
12
D4744S-K P1-25 (040202).p65
a
I I I I I DECK
TV
TV
Antenna or Cable
IN
OUT
or
1
Disconnect antenna or cable from TV
and connect to DECK.
2
Connect DECK to TV with RF Coaxial Cable.
TV
IN FROM ANT.
VHF/UHF
OUT TO TV
12
(supplied) or an AV Cable
I I I I I Cable Box
DECK
IN
Cable Box
OUT
RF COAXIAL CABLE
a
(supplied)
VHF/
UHF
AUDIO IN
VIDEO
R
L
IN
b
AV CABLE
(not supplied)
2004/02/02, 15:10
b
TV