Troubleshooting - pro-intell 2408C PRO KGB Manuel D'utilisation

Troubleshooting

Failure Reason Solution
Power cord is not connected to the
Connect power cord to the mains.
mains.
Power indicator does not light
Power switch is not in ON position Press ON button.
Pull-out bin is not pushed in up to the
Push in the basket.
end.
The paper is too thin. Shred more paper or fold up the paper
Power indicator is lit
Switch off power and continue
The motor is overheated.
but the motor does not start.
operation not earlier than in 30 min.
Waste bin is overfilled. (Red indicator
Empty the waste bin.
is lit, sound signal is heard)
Start sensor of receiving chute may be Clear the paper blockage at the auto
Shredder runs continuously
clogged with paper. start sensor (center) location.
The motor works, but the paper is not
- Insert paper against the stop.
captured.
If none of the above applies and the equipment still does not run, please contact the appropriate
customer service centre.
14