Troubleshooting - pro-intell 2005C PRO KGB Manuel D'utilisation

Troubleshooting

Fehler Mögl. Ursache Lösung
Power cord is not connected to the
Connect power cord to the mains.
mains.
Power switch is not in ON position Press ON button.
Power indicator does not light
Pull-out bin is not pushed in. Push in the bin.
The paper is too thin. Shred more paper or fold up the paper.
Switch off power and continue
The motor is overheated.
operation not earlier than in 30 min.
Power indicator is light but the motor
does not start.
Waste bin is overfilled. (Red indicator
Empty the waste bin.
is lit, sound signal is heard)
Start sensor of receiving chute may be Clear the paper blockage at the auto
Shredder runs continuously
clogged with paper. start sensor (center) location.
The motor works, but the paper is not
The paper was not inserted properly. Insert paper against the stop.
captured.
If none of the above applies and the equipment still does not run, please contact the
appropriate customer service department at his expense.
14