Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
F
AN SPEED AND
AIRFLOW DIRECTION ADJUSTMENT
Press
to select fan speed. Each press changes
fan speed in the following order:
(AUTO)
(Low)
(Med.)
• Two short beeps are heard from the indoor unit when set to AUTO.
Press
(AUTO)
(1)
(2)
• Two short beeps are heard from the indoor unit when set to AUTO.
Airflow direction
(AUTO) .......... The vane is set to the most efficient airflow direction. COOL/
DRY:horizontal position. HEAT:position (5).
(Manual)......... For efficient air conditioning, select the upper position for COOL/
DRY, and the lower position for HEAT. If the position (4) or (5) is
selected during COOL/DRY, the vane automatically moves to the
upward position after 0.5 to 1 hour to prevent any condensation from
dripping.
(Swing)........... The vane moves up and down intermittently.
■
Move the vertical vane manually before starting operation.
(High)
(Super High)
(3)
(4)
(5)
(SWING)
E
CONO COOL OPERATION
Press
during COOL mode
NO COOL operation.
The unit performs swing operation vertically in various cycle according
to the temperature of the airflow. Set temperature is set 4°F (2°C) higher
automatically.
Press
again to cancel ECONO COOL operation.
• ECONO COOL operation also is cancelled when the VANE button is
pressed.
What is "ECONO COOL"?
even though the set temperature is automatically set 4°F (2°C) higher, it is possible
to perform cooling operation with keeping comfort. As a result, energy can be saved.
T
IMER OPERATION (ON/OFF TIMER)
1
Press
during operation to set the timer.
Each press changes timer mode in the following order:
(OFF TIMER)
(ON TIMER)
2
Press
to set the time of timer.
Each press increases or decreases the set time by 1 hour.
Press
until "TIMER RELEASE" is selected to
release timer.
Note:
• ON and OFF timers can not be used in combination.
• If power failure occurs while ON/OFF timer is set, see
function".
page 5
to start ECO-
TIMER
RELEASE
page 5
"Auto restart
En-6
Publicité
Table des Matières
