Save Operation; Econo Cool Operation - Mitsubishi Electric MFZ-KA25VA Notice D'utilisation

i

-save OPERATION

1
Press to select i-save mode. Select i-save during
COOL, ECONO COOL, or HEAT operation.
• The operation indicator lamp on the right side of the indoor unit lights
in orange.
2
Set the temperature, fan speed, and air fl ow direction.
• The same setting will be selected from the next time by simply press-
ing .
• Two groups of setting can be saved. (one for COOL/ECONO COOL,
one for HEAT)
Press again to cancel i-save operation.
• Pressing will also cancel i-save operation.
• The operation indicator lamp on the right side of the indoor unit turns
off or changes from orange to green.
i-save operation
A simplifi ed set back function enables to recall the preferred (preset) setting with
a single push of the button. Press the button again and you can go back to
the previous setting in an instance.
Example of use:
1. Low energy mode
Set the temperature 2 to 3ºC warmer in COOL and cooler in HEAT mode.
This setting is suitable for unoccupied room, and while you are sleeping.
2. Saving frequently used settings
Save your preferred setting for COOL/ECONO COOL and HEAT. This ena-
bles you to select your preferred setting with a single push of the button.
E
CONO COOL OPERATION
Press during COOL mode

ECONO COOL operation.

The unit performs swing operation vertically in various cycle according
to the temperature of the unit. Set temperature is set 2°C higher auto-
matically.
Press again to cancel ECONO COOL operation.
• Pressing also cancels ECONO COOL operation.
What is "ECONO COOL"?
Swing air fl ow (change of air fl ow) makes you feel cooler than constant air fl ow. So,
even though the set temperature is automatically set 2°C higher, it is possible to
perform cooling operation with keeping comfort. As a result, energy can be saved.
T
IMER OPERATION (ON/OFF TIMER)
1
Press or during operation to set the timer.
(ON timer) : The unit turns ON at the set
time.
(OFF timer) : The unit turns OFF at the set
time.
* or blinks.
* Make sure that the current time is set correctly.
2
Press (Increase) and
time of timer.
Each press increases or decreases the set time by 10 minutes.
3
Press or again to cancel timer.
Note:
• ON and OFF timers can be used in combination.
of timer operations.
• If power failure occurs while ON/OFF timer is set, see
function".
page 4 to start
Page 3
(Decrease) to set the
mark indicates the order
page 4 "Auto restart
En-6