Safety And Operating Instructions - solamagic S1 1400 Instructions De Montage Et D'utilisation

Safety and operating instructions

Please observe the following instructions:
Carefully read through the instruction manual prior to installation and store the
manual safely.
This heater can be used by children aged 8 years or older and persons with redu-
ced physical, sensory or mental capabilities or lack of experience and knowledge,
provided they have been given supervision or instruction regarding the safe use
of the device and that they understand the resulting risks. Children must not play
with the heater.
Children younger than 3 years old must be kept away from the heater unless they
are continuously monitored.
Children older than 3 and younger than 8 years may only switch the heater on
and off if they are monitored or have been taught how to use the heater safe-
ly and have understood the resulting dangers; this provided that the heater is
placed or installed in its normal place of use. Children older than 3 and younger
than 8 years must not plug the heater into the wall socket, adjust the heater, clean
the heater and/or perform any user maintenance
Caution - Some parts of this product can become very hot and cause burns.
Special care is required when children and vulnerable persons are present.
• Installation tasks must be properly carried out by a qualified person in ac-
cordance with VDE 0100 installation instructions (if applicable, also including
Parts 559 and 701).
• When carrying out any work, always switch the system to a zero-volt state
(disconnect mains plug; circuit-breaker off). Switch on the heater only after all
the cables have been completely connected.
• The heater must be protected with at least a 16A (slow) fuse.
• Do not install directly under sockets, junction boxes, switches or electrical
cabling.
• Electrical sockets may only be located in the positions specified in Appendix 2.
• Do not mount the radiant heater close to curtains or combustible materials in
accordance with VDE 0100, Part 559.
• The device meets the requirements for protection type IP 44, if all connectors
(device plug, plugs for expansion components) are plugged in and it is appro-
ved for indoor and outdoor use. The connectors need to remain plugged in if
the device is used outdoors.
• If being used in wet rooms, observe the installation instructions, VDE 0100,
Part 701. Heaters must be installed in bathrooms such that the switch cannot
17
08/2016