Led Indicators; How To Use - TaoTronics TT-BA07 Mode D'emploi

LED Indicators

LED Indicator Status
Charging
Solid Red LED
LED Off Fully charged
Pairing in Transmitter
Flashing Red
/ Receiver Mode
and Blue
Low battery
Flashing Red
Successfully paired
Solid Blue LED
Flashing Blue
Powered on but not paired
(Every 2 Seconds)
with Bluetooth
Note:
• For rst time use, once powered on, the adapter
will automatically enter pairing mode. Please
follow the instructions below on how to pair.

How to Use

Charging
1. Connect the micro-USB end of the charging
cable to the charging port of the Bluetooth
adapter.
2. Plug the USB end of the charging cable to a USB
charging port or any active USB port.
devices
®
®
3. The LED indicator will turn red when charging. It
will automatically turn off when the device is fully
charged.
Note:
• You can use the adapter while it is charging.
• We recommend charging the unit for at least 2
hours before using it for the rst time.
Pairing
Pair in TX mode:
1. Set the TT-BA07 to TX mode and connect it to your
audio transmitting device.
2. Place your Bluetooth
audio receiving device
®
within a 3 feet / 1 meter range and set it to pairing
mode.
3. Press and hold the Power Button for 5 seconds (LED
indicator ashes blue slowly) and tap twice to enter
pairing mode (LED indicator ashes red and blue
alternately). After approximately 30 seconds, the
pairing will be done (LED indicator in solid blue).
Pair in RX mode:
Press and hold the Power Button of the adapter for 5
seconds (LED indicator ashes blue slowly). It will
start pairing 5 seconds after being powered on (LED
indicator ashes red and blue alternatively).
1. Activate the Bluetooth
®
and search for the nearby Bluetooth
• For iOS: Settings > Bluetooth
• For Android: Settings > Wireless & Networks >
Bluetooth : On > Scan for devices
®
function on your phone
devices:
®
> On
®
05/06